Extruder Rupture Disk – Temperature Derating
MPI’s extruder rupture disks incorporate a standard Inconel burst disk. The Inconel disk allows the bursts plugs to be used over a wide temperature range with minimal burst pressure changes (a change of approximately 2% over the 300°F-600°F range). The chart below will help users estimate changes in rating based on temperature.
Full engineering support is available via email and phone.
MPI also carries a complete line of melt pressure products, including melt pressure transducers, melt pressure transmitters, melt pressure indicators, melt pressure cables, connectors, hole plugs, hole drill kits, and hole clean kits.
Request a quote on extruder rupture disks. Contact MPI to learn more. Still not finding what you are looking for? Call us at (800) 817-3486 to find out more.
Temperature Derating of MPI Extruder Rupture Disks (Inconel)
Note: The above chart is only valid for Inconel disk material. Other materials will have different derating curves.Full engineering support is available via email and phone.
MPI also carries a complete line of melt pressure products, including melt pressure transducers, melt pressure transmitters, melt pressure indicators, melt pressure cables, connectors, hole plugs, hole drill kits, and hole clean kits.
Request a quote on extruder rupture disks. Contact MPI to learn more. Still not finding what you are looking for? Call us at (800) 817-3486 to find out more.
Full engineering support is available via email or by clicking on the Sales/Support LiveChat button below.
